5.
Push down on the idler pulley to ensure that the
idler-pulley assembly pivots freely.
Completing the Installation
1.
Check the alignment of the belt and pulleys; refer
to
Checking the Pulley Alignment (page 10)
.
2.
Slide the belt cover onto the mounting bolts and
secure the cover with 2 flange nuts (
).
Important:
Do not overtighten the nuts as
damage to the cover may occur.
g193167
Figure 16
1.
Setscrew installed
3.
Belt cover
2.
Setscrew removed
3.
Remove the bottom setscrew for drainage.
Important:
Ensure that the top setscrew is
installed.
4.
Lubricate the grease fittings on each of the
roller brush bearing housings with No. 2 lithium
grease (
).
Note:
Wipe off any excess grease, specifically
around the excluder seals.
g035892
Figure 17
8
