Form No. 3411-973 Rev B
Rear Roller Brush MVP Kit
Reelmaster
®
3555, 3575, 5010, and 5010-H Series 22-inch Cutting
Unit with 5-inch or 7-inch Reel and Universal Groomer
Model No. 133-0153
Model No. 133-0154
Installation Instructions
This product complies with all relevant European directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Qty.
Use
No parts required
–
Determine the position of the roller brush and the reel
motor.
Roller-brush assembly
1
90-degree grease fitting
1
Install the roller-brush assembly.
Carriage bolt (Model 133-0153 only—only for
5-inch cutting units driven by hydraulic reel
motors)
2
Weight (Model 133-0153 only—only for 5-inch
cutting units driven by hydraulic reel motors)
1
Locknut (Model 133-0153 only—only for
5-inch cutting units driven by hydraulic reel
motors)
2
Install the weight (Model 133-0153 only).
Weight—Part No. 132-0735-03 (sold
separately)
1
Carriage bolt (5/16 x 2 inch)—Part No. 3230-6
(sold separately)
2
Bolt (5/16 x 1/2 inch)—Part No. 322-1 (sold
separately)
2
Washer (5/16 inch)—Part No. 3256-23 (sold
separately)
2
Flange nut (5/16 inch)—Part No. 104-8300
(sold separately)
2
Install the additional weight parts needed for RM5010-H
5-inch and 7-inch, RM3575, RM5510, and RM5610.
Retaining ring
1
Belt-cover/plate assembly
1
Bolt (5/16 x 5/8 inch)
2
Install the roller-brush plate.
No parts required
–
Position the roller brush.
Drive pulley
1
Flange-head bolt (5/16 x 1/2 inch)
1
Belt
1
Install the drive pulley and the belt.
No parts required
–
Complete the installation.
High height-of-cut brush (optional)
—
Install the high height-of-cut brush—for HOC greater than
2.5 cm (1 inch).
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3411-973* B
