Toro reelmaster 3550 series, Руководство по установке

Страница: 1 / 16

Form No. 3397-660 Rev B
Rear Roller Brush Kit
Reelmaster ® 3550 Series 18-inch Cutting Unit with 5-inch Reel
and Universal Groomer
Model No. 03657
Installation Instructions
This product complies with all relevant European directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description Qty. Use
No parts required
–
Determine the position of the roller brushes and the reel
motors.
Roller-brush assembly 5
Retaining ring 5
Right belt-cover/plate assembly 2
Left belt-cover/plate assembly 3
90-degree grease fitting
5
Carriage bolt 10
Weight 5
Locknut 10
Drive pulley 5
Hex-drive bolt (5/16 x 1/2 inch)
15
Belt 5
Shim washer (as required for belt alignment) 5
Belt-alignment tool 1
Front bumper assembly 1
Washer 2
Rear bumper assembly 1
Install the kit.
High height-of-cut brush (optional)
—
Install the high height-of-cut brush—for HOC greater than
2.5 cm (1 inch).
Note:
Install the universal groomer kit first; refer to
the groomer installation instructions.
Important:
Use the Rear Roller Brush Kit only
when cutting in the height-of-cut range of 6 to
25 mm (1/4 to 1 inch). Use the high height-of-cut
brush when cutting above 25 mm (1 inch). Refer to
the procedure for Installing the High Height-of-Cut
Brush (Optional).
Note:
Determine the left and right sides of the cutting
unit from behind the cutting unit.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420 Register at www.Toro.com. Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3397-660* B