Toro Recycler 21762, Руководство оператора

Страница: 17 / 28

•
Wet grass and leaves tend to clump on the yard
and can cause the machine to plug or the engine
to stall. Avoid mowing in wet conditions.
•
Be aware of a potential fire hazard in very dry
conditions, follow all local fire warnings, and keep
the machine free of dry grass and leaf debris.
•
Alternate the mowing direction. This helps
disperse the clippings over the lawn for even
fertilization.
•
If the finished lawn appearance is unsatisfactory,
try 1 or more of the following:
– Replace the blade or have it sharpened.
– Walk at a slower pace while mowing.
– Raise the cutting height on your machine.
– Cut the grass more frequently.
– Overlap cutting swaths instead of cutting a full
swath with each pass.
Cutting Leaves
•
After cutting the lawn, ensure that half of the lawn
shows through the cut leaf cover. You may need
to make more than a single pass over the leaves.
•
If there are more than 13 cm (5 inches) of leaves
on the lawn, mow at a higher cutting height and
then again at the desired cutting height.
•
Slow down your mowing speed if the machine
does not cut the leaves finely enough.
After Operation
After Operation Safety
General Safety
•
Always shut off the machine, remove the
electric-start button (if equipped), wait for all
moving parts to stop, and allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the machine to help
prevent fires. Clean up oil or fuel spills.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
Hauling Safety
•
Remove the electric-start button (if equipped)
before loading the machine for hauling.
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.
Cleaning under the Machine
Service Interval: Before each use or daily
For best results, clean the machine soon after you
have completed mowing.
1. Move the machine onto a flat paved surface.
2. Shut off the engine and wait for all moving parts
to stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height
setting. Refer to
Adjusting the Cutting Height
(page 12) .
4. Wash out the area under the rear door where the
clippings go from the underside of the machine
to the grass bag.
Note:
Wash out the area with the
bag-on-demand (if equipped) in both the fully
forward and fully rearward positions.
5. Attach a garden hose that is connected to a
water supply to the washout port (
Figure 20 ).
17