move the lever rearward until the button on the
lever pops up.
Important:
For proper operation, shut off
the engine, wait for all moving parts to stop,
and then remove any grass clippings and
debris from the bag-on-demand door and the
surrounding opening (
) before you
move the bag-on-demand lever from 1 position
to another.
g027454
Figure 18
1.
Clean here
Side-Discharging the
Clippings
Use side-discharging for cutting very tall grass.
If the grass bag is on the machine and the
bag-on-demand lever is in the bagging position, move
the lever to the recycling position; refer to
the Bag-on-Demand Lever (page 15)
.
Installing the Side-Discharge
Chute
Unlatch and lift up the side deflector and install the
side-discharge chute (
g235646
Figure 19
Removing the Side-Discharge
Chute
To remove the side-discharge chute, lift up the side
deflector, remove the side-discharge chute, and lower
the side-discharge deflector until it latches securely.
Operating Tips
General Mowing Tips
•
Inspect the area where you will use the machine
and remove all objects that the machine could
throw.
•
Avoid striking solid objects with the blade. Never
deliberately mow over any object.
•
If the machine strikes an object or starts to vibrate,
immediately shut off the engine, disconnect the
wire from the spark plug, remove the electric-start
button (if equipped), and examine the machine for
damage.
•
For best performance, install a new blade before
the cutting season begins.
•
Replace the blade when necessary with a Toro
replacement blade.
Cutting Grass
•
Cut only about a third of the grass blade at a time.
Do not cut below 51 mm (2 inches) unless the
grass is sparse or it is late fall when grass growth
begins to slow down.
•
When cutting grass over 15 cm (6 inches) tall,
mow at the highest cutting height setting and walk
slower; then mow again at a lower setting for the
best lawn appearance. If the grass is too long, the
machine may plug and cause the engine to stall.
16
Содержание Recycler 21762
Страница 28: ......