Toro Recycler 21050B, Руководство оператора

Страница: 12 / 16

7
2. Plug end of extension cord into a normal
household outlet.
3. Press down button and squeeze control bar to
handle (Fig. 10). Release button.
To Stop Motor
1. Release control bar.
2. Disconnect extension cord from household outlet
if mower will be unattended for any period of
time.
Grass Bag
Installing
1. Stop motor, unplug extension cord and wait for
all moving parts to stop.
2. Raise discharge door, slide bag ramp attached to
bag into discharge opening, and hook bag frame
onto mounting bracket (Fig. 11). Allow
discharge door to rest on top of bag (Fig. 12).
Removing
1. Stop motor, unplug extension cord and wait
for all moving parts to stop. For protection,
always keep hands and feet away from mower
housing while motor is running. Raise discharge
door. While holding discharge door up, grasp
handle on grass bag and lift bag off mower.
Allow discharge door to close.
Note: When removing the grass bag, the bag
ramp scoops out any clippings that
may be plugging the discharge
opening. If the discharge opening
remains plugged, clear all clippings
from the mower with a stick.
Emptying
1. Grasp bag frame handle and rear of grass bag.
Gradually tip bag forward to empty clippings.
Discharge Tunnel Plug
1. Stop motor, unplug extension cord and wait for
all moving parts to stop.
2. Open discharge door and insert plug into
discharge tunnel opening (Fig. 6). Since the plug
is slightly wider than the discharge tunnel
opening, you must rotate the plug clockwise
slightly while inserting it.
3. Push plug all the way into the discharge tunnel
opening.
4. Lower discharge door over plug.
Adjusting Cutting Height
The six (6) letters on the belt cover represent the
height-of-cut settings. All wheels automatically adjust
to the same height-of-cut setting.
1. Stop motor, unplug extension cord and wait for
all moving parts to stop.
2. Use one or two fingers to squeeze the
height-of-cut adjustment lever (Fig. 13).
To raise the wheel height, squeeze the lever to
unlock the height-of-cut and pull up on the
mower. Release lever when desired height is
found. To lower the height, squeeze the
height-of-cut adjustment lever and push down on
the mower while rolling the mower forward.
Use the pointer on the link rod to locate the
correct setting.
3. Make sure the height adjustment lever is locked
into a height setting before beginning operation.
The height should not change when the
height-of-cut is locked.