Toro Recycler 20373, Руководство оператора

Страница: 11 / 24

g027908
Figure 13
1. Raise the machine 2. Lower the machine
Note:
The cutting height settings are 25 mm (1 inch); 35 mm
(1-3/8 inches); 44 mm (1-3/4 inches); 54 mm (2-1/8 inches);
64 mm (2-1/2 inches); 73 mm (2-7/8 inches); 83 mm (3-1/4
inches); 92 mm (3-5/8 inches); and 102 mm (4 inches).
Starting the Engine
1. If the ignition switch on your machine ( Figure 14 ) is a
toggle switch (with both an “I” and a “Stop”), push the
switch to the (“I”) position. Otherwise, go to step
2 .
G017317
Figure 14
1. Ignition toggle switch
2. Pull the recoil starter lightly until you feel resistance,
then pull it sharply (
Figure 15 ). Allow the rope to
return to the handle slowly.
Figure 15
Note:
If the machine does not start after several
attempts, contact an Authorized Service Dealer.
Using the Self-Propel Drive
To operate the self-propel drive, simply walk with your hands
on the upper handle and your elbows at your sides, and the
machine will automatically keep pace with you (
Figure 16 ).
Figure 16
Note:
If the machine does not freely roll backward after
self-propelling, stop walking, hold your hands in place, and
allow the machine to roll a couple of inches/centimeters
forward to disengage the wheel drive. You can also
try reaching just under the personal pace handle to the
metal handle and push the machine forward a couple
of inches/centimeters. If the machine still does not roll
backward easily, contact an Authorized Service Dealer.
11