g315988
Figure 6
Hook installed
1.
Right side
2.
Left side
4
Installing the Rear Bumper
Parts needed for this procedure:
1
Rear bumper
4
Bolt
8
Flat washer
4
Locknut
4
Cable ties
Procedure
1.
Remove the hardware from the rear bumper
(
).
2.
Install the rear bumper under the hopper with
the previously removed hardware (
).
3.
Connect the wire harness to the machine
harness.
4.
Verify that the left and right turn lights are
hooked up correctly by using the turn signal. If
needed, change the connections.
5.
Use the cable ties to fasten the wire harness to
the rear bumper.
g316095
Figure 7
1.
Rear bumper
3.
Washer
2.
Bolt
4.
Locknut
5
