17
2. Align the fuel tank to the top of the rear frame, and
secure the right side of the fuel tank with 2 bolts (5/16 x
3/4 in.), 2 lock washers (5/16 in.), and 2 washers
(5/16 in.) (Fig. 13).
m–3771
1
2
3
5
4
6
3
Figure 13
1.
Bolt , 5/8 x 7/8 in. (2)
2.
Lock washer, 5/16 in. (2)
3.
Washer, 5/16 in. (2)
4.
Stud (2)
5.
Spring (2)
6.
Locknut (2)
3. Secure the fuel tank studs to the frame with 2 washers
(5/16 in.), 2 springs, and 2 locknuts (5/16 in.) (Fig. 13).
Note: Tighten the left side of the fuel tank until it is
completely tight, then unscrew the locknut one full turn.
This allows the spring to work.
4. Push the fuel line onto the fuel tank fitting, and secure
the fuel line with a hose clamp (Fig. 14).
m–3778
3
2
1
Figure 14
1.
Fuel line
2.
Hose clamp
3.
Fuel fitting
Installing the Muffler
1. Loosen the clamp (Fig. 15).
m–5941
1
2
3
Figure 15
1.
Muffler
2.
Clamp
3.
Muffler bracket
2. Rotate the muffler forward into the position shown in
Figure 15.
3. Secure the muffler bracket (Fig. 15) to the engine
bracket with the hardware provided.
4. Tighten the clamp.
Hydro Linkage Set Up
Perform the following adjustments when the machine is
first set up and when any adjustment is needed. Do them in
the order that they are listed here.
Adjust Speed Control Linkage
Refer to Adjusting Speed Control Linkages on page 36.
Adjust Neutral Control Linkages
Refer to Adjusting Neutral Control Linkages on page 37.
Adjust Hydro Control Linkages
Refer to Adjusting Hydro Control Linkages on page 38.
Adjust Control Rods
Refer to Adjusting Control Rods on page 39.
Adjust Tracking
Refer to Adjusting Tracking on page 40.
