Toro Proline 30291, Руководство оператора, Страница: 16 / 48

16
5. Make sure the vent caps are installed in the battery.
Charge the battery for 1 hour at 25 to 30 amps or 6
hours at 4 to 6 amps. Do not overcharge the battery.
Checking the Hydraulic Fluid
Check the hydraulic fluid level before engine is first
started.
Fluid Type: Mobil 1 15W-50 synthetic motor oil or
equivalent synthetic oil.
Important
Use oil specified or equivalent. Other
fluids could cause system damage.
Hydraulic System Oil Capacity: 67 oz. (2.0 l)
1. Position machine on a level surface and chock or block
tires.
2. Clean area around filler neck of hydraulic tank
(Fig. 7).
3. Remove cap from filler neck. Look inside to check if
there is fluid in the reservoir (Fig. 7).
4. If there is no fluid, add fluid to reservoir
approximately a 1/4 in. (6mm) below the top of baffle.
5. Run the machine 15 minutes to allow any air to purge
out of the system and warm fluid.
6. Recheck level while fluid is warm. Add fluid to raise
level to top of the baffle, if required.
Note: Fluid level should be to the top of the baffle when
fluid is warm (Fig. 7).
7. Install cap on filler neck.
2
1
3
M-4280
Figure 7
1. Cap
2. Baffle
3. Fluid level—full
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
•
If hydraulic fluid is injected into the skin it
must be surgically removed within a few hours
by a doctor familiar with this type of injury.
Gangrene may result if this is not done.
•
Keep body and hands away from pin hole leaks
or nozzles that eject high pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
•
Make sure all hydraulic fluid hoses and lines
are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to hydraulic system.
Warning
Install Hairpin Cotter Pins
Spare height–of–cut spacers may be stored on posts and
retained by a hairpin cotter.
1. On opposite side of muffler, install extra hairpin cotter
pins into front and rear height–of–cut pins (Fig. 8).
1
2
m–5314
3
Figure 8
1. Hairpin cotter
2. Extra spacers
3. Height–of–cut post
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.