Toro ProLine 30168, Руководство оператора

Страница: 18 / 44

Assembly
16
Install Control Rods
1. Thread rod fittings equal distance onto each
control rod. For a starting point thread on
approximately 2 in. (51 mm) (Fig. 9).
2. Slide clevis pins through rod fittings and
mounting holes in idler brackets (from outside)
(Fig. 9). Secure with washers and hairpin cotters
(Fig. 9).
m–2073
Figure 9
1. Control rod and fitting
2. 2 in. (51 mm)
3. Idler bracket
4. Clevis pin, washer and
hairpin cotter
3. Check the gap between upper control bar and
fixed bar with wheel drive fully engaged. Gap
should be approximately 1 to 1-1/4 in.
(25–32 mm) (Fig. 10).
Note: The upper control bar and fixed bar
must be parallel when in engaged,
drive, relaxed and brake positions.
4. Check operation. If adjustment is required,
remove hairpin cotter securing rod to upper
control bar. Thread rod in or out of fitting for
proper position and install into upper control bar
with hairpin cotter.
m–4191
Figure 10
1. Control rod
2. Fixed control bar
3. Parking brake lever
4. Upper control bar
5. Check parking brake adjustment. Brake rods
should be adjusted so parking brake lever is snug
when swung into position against the fixed bar
while pulling back on upper control bar
(Fig. 10).