Toro ProLine 30168, Руководство оператора

Страница: 17 / 44

Assembly
15
m–4712
1
Figure 6
1. Carburetor choke valve
Choke Adjustment
1. Place throttle control in CHOKE position.
2. Align the hole in the speed control lever with the
hole in the base plate (Fig. 5) by moving the
lever. Insert a 6 mm diameter pin or 6 mm bolt
through two holes.
3. Turn the choke setting screw so that the
clearance between the screw end and the tongue
of the lever is 2.7 mm (Fig. 5). Remove the
6 mm diameter pin or bolt.
Note: Make sure that the choke valve turns
from fully closed position to fully
opened position when moving throttle
control to FAST position.
Connect Wire Harness
1. Route wire harness along inside of left handle
bracket.
2. Plug clutch wire into connector (Fig. 7).
3. Secure the black ground wire to engine mount
with 5/16
nut (Fig. 7).
4. Secure wire harness to upper handle with cable
tie.
m–4713
1
2
Figure 7
1. Clutch wire connector 2. Ground wire
5. Route the other part of the wire harness around
to the right side of the engine and secure with
clamp and nut on engine base (Fig. 8).
6. Push the two wires together (Fig. 8).
m–4688
1
3
2
Figure 8
1. Clamp and nut
2. Wire harness
3. Engine wire