Toro ProLine 30165, Руководство оператора

Страница: 17 / 40

Set-Up
15
Connect Wire Harness
1. Secure clutch and engine in–line wire connectors
(Fig. 6).
1
2
2153
Figure 6
1. Clutch wire connector 2. Engine wire connector
2. Remove top jam nut from right rear engine
mounting bolt located behind oil dipstick.
3. Mount remaining wire to engine bolt and secure
with jam nut.
Install Control Rods
1. Thread a rod fitting onto each control rod
approximately 2 in. (51 mm) (Fig. 7) or until
upper control bar (Fig. 8). is approximately
perpendicular to the ground.
2. Mount rod fitting ends to mounting holes in idler
brackets (from outside) with clevis pins, washers
and hairpin cotters (Fig. 7).
2154
1
3
2
4
4
Figure 7
1. Control rod and fitting
2. 2 in. (51 mm)
3. Idler bracket
4. Clevis pin, washer and
hairpin cotter