Toro ProCore, Руководство по обслуживанию

Страница: 23 / 122

ProCore Processor Page 3 -- 9 Engine
Check Fuel Lines and Connections
Check fuel lines and connections periodically as recom-
mended in the Operator’s Manual. Check fuel lines for
deterioration, damage or leaking connections. Replace
hoses, clamps and connections as necessary.
Drain and Clean Fuel Tank
Drain and clean the fuel tank periodically as recom-
mended in the Operator’s Manual. Also, drain and clean
the fuel tank if the fuel system becomes contaminated
or if the machine is to be stored for an extended period.
To clean fuel tank, flush tank out with clean solvent.
Make sure tank is free of all contaminates and debris.
Fuel Tank Removal (Fig. 9)
1. Make sure machine is parked on a level surface with
the engine OFF. Remove key from ignition switch. Re-
move spark plug wires from the spark plugs to prevent
the engine from starting unexpectedly.
2. Use a fuel transfer pump to remove fuel from the fuel
tank and into a suitable container.
3. Disconnect fuel hose from the stand pipe fitting on
top of tank.
4. Remove four (4) cap screws and flat washers that se-
cure tank straps to machine. Remove straps. Make sure
that tinnerman nuts remain positioned correctly on
frame brackets for assembly purposes.
5. Lift fuel tank from machine.
6. Remove stand pipe and bushing from fuel tank if nec-
essary (Fig. 7). Discard bushing if removed.
Fuel Tank Installation (Fig. 9)
1. If removed, install new bushing and stand pipe into
fuel tank (Fig. 7).
2. Position fuel tank and tank straps to machine frame.
3. Secure straps and fuel tank with four (4) cap screws
and flat washers.
4. Connect fuel hose to the stand pipe fitting on top of
tank. Secure hose with worm clamp.
5. Connect spark plug wires to spark plugs.
Figure 7
1. Fuel tank
2. Stand pipe
3. Bushing
1
2
3
Engine