5
Installing the Power Wire
Harness
Parts needed for this procedure:
1
Power wire harness
2
Cable tie
1
Fuse
Procedure
1.
Disconnect the battery from the vehicle.
2.
Attach the power wire harness ring terminal to
the ground bolt near the vehicle fuse block.
3.
Plug the harness wire into the red wire on the
back of the fuse block.
Note:
If the Workman vehicle does not have
an open fuse slot, obtain and install a Toro
accessory fuse block (Part No. 92-2641).
4.
Insert the 20 A fuse into the slot in the fuse block
(
).
g248241
Figure 7
1.
Fuse
2.
Fuse block
5.
Route the wire harness alongside the main
vehicle wire harness to the rear of the vehicle
(
).
g010992
Figure 8
1.
Power wire harness
6.
Secure the wire harness to the vehicle in several
places with cable ties. Keep the harness away
from any hot or rotating components.
Note:
The harness is equipped with a connector
for the optional brake control kit.
7.
Connect the vehicle battery; refer to the vehicle
Operator’s Manual
.
12
Содержание Pro Sweep 07068
Страница 31: ...g011025 Figure 33 g011026 Figure 34 g011027 Figure 35 g011028 Figure 36 g011029 Figure 37 g011030 Figure 38 31 ...
Страница 36: ...Notes ...
Страница 37: ...Notes ...
