Toro POWERVAC 51985, Руководство оператора

Страница: 17 / 76

17 Operation
Vacuum Operation
See Figure 14.
WARNING:
Never run the unit without the vacuum tubes
and vacuum bag installed. Failure to do so could
result in serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Keep the muffler and all hot surfaces of the
blower/vacuum away from your body. Failure
to do so could result in possible serious personal
injury.
1.
Install the vacuum tubes, vacuum handle, and bag.
Refer to the Assembly section earlier in this manual.
2. Start the engine. Refer to Starting and Stopping earlier
in this manual.
3.
Place the vacuum bag strap over your right shoulder.
Hold the upper handle in your left hand and the vacuum
handle in your right hand.
4. Move the vacuum from side to side along outer edge of
the debris. To avoid clogging, do not place the vacuum
tube directly into the debris pile.
5.
Hold the engine higher than the inlet end of the vacuum
tube.
6.
Always point vacuum tube downhill when working on a
hillside.
7. To avoid injury to the operator or unit, do not pick up
rocks, broken glass, bottles, or other similar objects.
8.
If the vacuum tubes should clog, stop the engine and
disconnect the spark plug wire before cleaning out the
obstruction.
9. Remove the vacuum tubes and clear the debris from
the blower fan housing. Remove the bag and clear the
adaptor. A small rod or stick may be required to clear
the entire tube length. Ensure that all debris has been
cleared before reassembling the vacuum tubes.
Figure 14
Proper Operating Position
Hold Muffler Away From Body And Clothing