Toro Power Max Heavy Duty 826 OXE, Руководство оператора

Страница: 24 / 32

Changing the Engine Oil
Service Interval: After the first 5 hours—Change the engine
oil.
Every 25 hours/Yearly (whichever comes
first)—Change the engine oil.
If possible, run the engine just before changing the oil because
warm oil flows better and carries more contaminants.
Use automotive detergent oil with an API service classification
of SF, SG, SH, SJ, SL, or higher. Refer to your engine owner's
manual.
Use Figure 52 below to select the best oil viscosity for the
outdoor temperature range expected:
Figure 52
Engine Oil Capacities
Model Engine Oil Capacity
38800 0.53 to 0.59 L (18 to 20 oz)
1. Clean the area around the oil drain cap (Figure 53).
Figure 53
1. Oil drain cap
2. Slide an oil drain pan under the drain extension and
remove the oil drain cap.
3. Drain the oil.
Note:
Dispose of the used oil properly at a local
recycling center.
4. Install the oil drain cap.
5. Fill the crankcase with oil. Refer to 6 Filling the Engine
with Oil (page 11).
Lubricating the Hex Shaft
Service Interval: Yearly—Lubricate the hex shaft.
Lightly lubricate the hex shaft yearly with automotive engine
oil (Figure 54).
Figure 54
1. Hex shaft 3. Rubber wheel
2. Aluminum friction plate
Important:
Do not get oil on the rubber wheel or the
aluminum friction drive plate because the traction drive
will slip (Figure 54).
1. Drain the gasoline from the fuel tank.
2. Tip the machine forward onto its auger housing and
block it so that it cannot fall.
3. Remove the back cover (Figure 55).
Figure 55
1. Back cover
4. Move the speed selector lever to Position R2.
5. Dip your finger in automotive engine oil and lightly
lubricate hex shaft.
6. Move the speed selector lever to Position 6.
7. Lubricate the other end of the hex shaft.
8. Move the speed selector lever forward and rearward
a few times.
9. Install the back cover and return the machine to the
operating position.
Replacing the Spark Plug
Service Interval: Every 100 hours—Replace the spark plug.
24