Toro Multi Pro WM 41240, Руководство оператора

Страница: 49 / 84

Important:
The tank markings are for reference
only and cannot be considered accurate for
calibration.
CAUTION
Chemicals are hazardous and can cause
personal injury.
• Read the directions on the chemical labels
before handling the chemicals, and follow
all manufacturer recommendations and
precautions.
• Keep chemicals away from your skin.
Should contact occur, wash the affected
area thoroughly with soap and clean water.
• Wear goggles and any other protective
equipment recommended by the chemical
manufacturer.
The Multi Pro WM has been specifically designed
to have high durability in order to give it the long
sprayer life you need. Different materials have been
chosen for specific reasons at different locations on
your sprayer to meet this goal. Unfortunately there is
no single material which is perfect for all foreseeable
applications.
Some chemicals are more aggressive than others
and each chemical interacts differently with various
materials. Some consistencies (e.g. wettable
powders, charcoal) are more abrasive and lead
to higher than normal wear rates. If a chemical is
available in a formulation that would provide increased
life to the sprayer, use this alternative formulation.
Remember to clean your sprayer thoroughly after all
applications. This will do the most to ensure your
sprayer has a long and trouble free life.
Filling the Fresh Water Tank
Always fill the fresh water tank with clean water before
handling or mixing any chemicals.
The fresh water tank is located on the ROPS, behind
the passenger seat (
Figure 69 ). It supplies a source of
fresh water for you to wash chemicals off of your skin,
eyes, or other surfaces in case of accidental exposure.
•
To fill the tank, unscrew the cap on the top of the
tank and fill the tank with fresh water. Replace
the cap.
•
To open the fresh water tank spigot, turn the lever
on the spigot.
g028487
Figure 69
1. Filler cap 3. Spigot
2. Fresh water tank
Filling the Spray Tank
Install the Chemical Pre-Mix Kit for optimal mixing and
exterior tank cleanliness.
Important:
Ensure that the chemicals you will
be using are compatible for use with Viton (see
the manufacturer's label; it should indicate if it
is not compatible). Using a chemical that is not
compatible with Viton will degrade the O-rings in
the sprayer, causing leaks.
Important:
After filling the tank for the first time,
check the tank straps for any play. Tighten them
as necessary.
1. Stop the sprayer on a level surface, move the
range selector to the Neutral position, stop the
engine, and set the parking brake.
2. Determine the amount of water needed to mix
the amount of chemical you need as prescribed
by the chemical manufacturer.
3. Open the tank cover on the spray tank.
Note:
The tank lid is located in the center of the
top of the tank. To open it, turn the front half of
the cover counterclockwise and swing it open.
You can remove the strainer inside for cleaning.
To seal the tank, close the cover and rotate the
front half clockwise.
4. Add 3/4 of the required water to the spray tank
using the anti-siphon fill receptacle.
Important:
Always use fresh clean water in
the spray tank. Do not pour concentrate into
an empty tank.
5. Start the engine, engage the PTO, and set the
hand throttle if equipped.
49