Toro Multi Pro 1750, Руководство оператора

Страница: 22 / 76

Specifications
Note:
Specifications and design are subject to
change without notice.
Weight with standard spray
system, empty, without
operator 953 kg (2,100 lb)
Weight with standard spray
system, full, without operator 1678 kg (3,700 lb)
Maximum gross vehicle weight
(GVW) (on level ground) 1814 kg (4,000 lb)
Overall length with standard
spray system 343 cm (135 inches)
Overall height with standard
spray system 191 cm (75 inches)
Overall height with standard
spray system to the top of
the sections stored in the X
position 246 cm (97 inches)
Overall width with standard
spray system sections stored
in the ‘X’ position 178 cm (70 inches)
Ground clearance 14 cm (5.5 inches)
Wheel base 155 cm (61 inches)
Tank capacity (includes the
CE 5% overflow) 662 L (175 US gallons)
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor.
To best protect your investment and maintain optimal
performance of your Toro equipment, count on Toro
genuine parts. When it comes to reliability, Toro
delivers replacement parts designed to the exact
engineering specification of our equipment. For peace
of mind, insist on Toro genuine parts.
Operation
Note:
Determine the left and right sides of the
machine from the normal operating position.
Safety First
Please carefully read all of the safety instructions and
decals in the safety section. Knowing this information
could help you or bystanders avoid injury.
Preparing to Drive the
Machine
Checking the Engine Oil
The engine is shipped with oil in the crankcase;
however, the level of oil must be checked before you
first start the engine and after you have run it.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag
(
Figure 11 ).
3. Insert the dipstick into the tube and make sure
that it is seated fully. Remove the dipstick and
check the oil level.
g023037
Figure 11
1. Filler cap 2. Dipstick
4. If the oil level is low, remove the filler cap from
the valve cover (
Figure 11 ) and pour oil into the
opening until the oil level is up to the F
ULL
mark
on the dipstick; refer to Servicing the Engine Oil
(page 43) for the proper oil type and viscosity.
Note:
Add the oil slowly and check the level
often during this process. Do not overfill.
5. Install the dipstick firmly in place.
22