Toro HydroJect 3010, Руководство по обслуживанию

Страница: 53 / 124

________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
________________________________________________________________________________________________________________________________________________________
General Run and Transport Problems
Condition Possible Cause Correction
Engine shuts down during trans- Not electrical - low engine oil pres- Find and correct cause of engine
port or when idling (not in Aerate sure, no fuel, etc. shut down.
mode).
Oil pressure switch faulty. Test switch and replace if faulty.
Loose or broken wire in oil pres- Check all wiring and connections
sure switch circuit. and repair as necessary.
Engine does not stop when igni- Engine timing or carburetor out of Adjust carburetor or engine tim­
tion key switch is rotated to OFF adjustment. ing.
position.
Ignition switch faulty. Test ignition switch and replace if
faulty.
Short in ignition circuit wiring. Check all wiring and connections
and repair as necessary.
Battery does not charge. Loose or damaged wire(s) in en- Check wiring and connections
gine electrical system. and repair as necessary.
Regulator or engine charging cir- Repair engine charging circuit.
cuit faulty.
Battery faulty. Test battery and replace if faulty.
Machine does not lower (to aer- Lift/lower switch faulty. Test switch and replace if faulty.
ate position).
Ignition key switch faulty. Test ignition switch and replace if
faulty.
Loose or broken wire in lift down Check all wiring and connections
circuit. and repair as necessary.
Linear actuator faulty. Test actuator and repair or re­
place if faulty.
Hydroject 3010 Page 5 - 9 Troubleshooting