Toro Groundsmaster 328-D, Руководство оператора

Страница: 20 / 56

20
1
2
Figure 9
1. Pivot shaft 2. Roll pin
4. Hold seat up with seat support rod (Fig. 10).
5. Plug wire harness connector into seat switch connector
on bottom of seat.
1
Figure 10
1. Seat support rod
6. Disengage seat support rod and pivot downward. Pivot
seat down and push lynch pin through seat latch stud.
Flip wire end of pin over latch stud (Fig. 11).
1
Figure 11
1. Lynch pin
7. Slide seat completely forward and backward to ensure
proper operation and that seat switch wires and
connectors are not pinched or do no contact any moving
parts.
Seat Kit, Model No. 30625, Deluxe Seat
with Model No. 30628 Seat Adapter Kit
1. Mount seat suspension assembly to 4 capscrews on seat
bottom and secure with 4 lock washers, flat washers,
and nuts (Fig. 12).
1
6
4
2
5
3
Figure 12
1. Seat suspension
assembly
2. R-clamps
3. Lock washer, flat washer,
and nut
4. Manual tube
5. Cap
6. Seat support
2. Loosely secure 2 R-clamps to right side of seat bottom
with 2 capscrews and flat washers supplied in kit
(Fig. 12). Install manual tube into R-clamps and tighten
capscrews (Fig. 12).
3. Mount seat support over four threaded studs at the
bottom of seat suspension assembly and secure in place
with flangenuts (Fig. 12).
4. Mount seat pivot bracket to frame with (2) flange
screws supplied in kit (Fig. 8)
5. Mount seat and seat support to seat pivot bracket with
pivot shaft and roll pin (Fig. 9).
6. Hold seat up with seat support rod (Fig. 10).
7. Route seat switch harness through holes in seat support
and seat suspension (Fig. 13). Plug wire harness
connector into seat switch connector on bottom of seat.