Toro Greensmaster eTriFlex 04590, Руководство оператора

Страница: 23 / 56

g289940
Figure 27
1. Center cutting unit 3. Front right cutting unit
2. Front left cutting unit
Using the InfoCenter
to Adjust the Machine
Settings
You can use the InfoCenter to adjust the following
machine settings:
•
Tap-off delay ; refer to Adjusting the Tap-Off Delay
(page 23) .
•
Reel speed while mowing ; refer to Adjusting the
Mowing Reel Speed (page 23) .
•
Reel speed while backlapping the cutting units ;
refer to Adjusting the Backlap Reel Speed (page
24) .
•
Clip control ; refer to Setting the Clip-Control
Feature (page 24) .
•
Height of cut (HOC) ; refer to Adjusting the Height
of Cut (HOC) (page 24) .
•
Number of cutting-unit blades ; refer to Adjusting
the Number of Cutting-Unit Blades (page 24) .
•
Maximum mowing speed ; refer to Adjusting the
Maximum Mowing Speed (page 24) .
•
Maximum transport speed ; refer to Adjusting the
Maximum Transport Speed (page 25) .
•
Maximum reverse speed ; refer to Adjusting the
Maximum Reverse Speed (page 25) .
•
Slow and turn ; refer to Setting the Slow and Turn
Function (page 25) .
•
Disabling an equipped 3-Wheel-Drive Kit ; refer
to Disabling an Equipped 3-Wheel-Drive Kit (page
25) .
•
Battery-reserve capacity ; refer to Setting the
Battery-Reserve Capacity (page 25) .
Note:
Each setting is passcode-protected. You may
need to enter a passcode to edit the settings.
Adjusting the Tap-Off Delay
Navigate to the T
APOFF
T
IME
option to adjust the
tap-off delay. The tap-off delay feature allows the
cutting units to turn off without raising. The delay
setting represents the maximum time for the lift/lower
joystick to remain in the rearward position to activate
this feature.
Refer to the following table for the delay time options
and their corresponding increment numbers:
Tap-Off Delay Options
Increment Number
Delay Time (Seconds)
1 Off
2 0.050
3 0.100
4 0.150
5 0.200
6 0.250
7 0.300
8 0.350
9 0.400
10 0.450
Note:
The factory default setting is 1, which disables
this feature.
Adjusting the Mowing Reel Speed
Navigate to the R
EEL
S
PEED
option to adjust the reel
speed while mowing. This setting can be adjusted
when the clip control setting is O
FF
; refer to Setting
the Clip-Control Feature (page 24) .
Refer to the following table for the reel speed options
and their corresponding increment numbers:
Mowing Reel Speed Options
Increment Number Reel Speed (RPM)
1 800
2 950
3 1100
4 1250
5 1400
23