Toro Greensmaster
3150, Руководство оператора

Страница: 17 / 48

Throttle Control
The throttle control (Figure 13) gives the operator the ability
to control the speed of the engine. Moving the throttle
control toward the Fast position increases the engine rpm;
moving the throttle control toward Slow will decrease the
engine rpm.
Note:
The engine cannot be stopped by the use of the
throttle control.
Figure 13
1. Throttle control 3. Leak detector test/light
switch
2. Choke control
Choke
To start a cold engine, close the carburetor choke by moving
the choke control (Figure 13) forward to the Closed position.
After the engine starts, regulate the choke to keep the engine
running smoothly. As soon as possible, open the choke by
pulling it rearward to the Open position. A warm engine
requires little or no choking.
Leak detector test/light switch
From the middle operating position, move the switch
(Figure 13) rearward to check the operation of the leak
detector alarm and time delay. Move the switch forward to
operate the optional lights.
Hour Meter
The hour meter (located on the left control panel) indicates
the total hours the machine has operated. It starts to function
whenever the key switch is rotated to On.
Seat Adjusting Lever
This lever, on the left side of the seat (Figure 14), allows a 10
cm (4 inch) fore and aft adjustment of the seat.
Figure 14
1. Seat adjustment lever
Raise/Lower Mow Control
Moving the control (Figure 15) forward during operation
lowers the cutting units and starts the reels. Pull back on the
control to stop the reels and raise the cutting units. During
operation the reels can be stopped by pulling back on the
control momentarily and releasing it. Restart the reels by
moving the control forward.
Figure 15
1. Functional control lever 3. Raise/lower mow control
2. Ignition switch
Functional Control Lever
The functional control lever (Figure 15) provides two traction
selections plus a Neutral position. It is permissible to shift
from mow to transport or transport to mow (not to neutral)
while the machine is in motion. No damage will result.
•
Rear Position-neutral and backlapping
•
Middle Position-used for mowing operation
•
Front Position-used for transport operation
Ignition Switch
Insert the key into the switch (Figure 15) and turn it clockwise
as far as possible to the Start position to start the engine.
Release the key as soon as the engine starts; the key will move
to the On position. Turn the key counterclockwise to the Off
position to stop the engine.
17