Toro Greensmaster
3150, Руководство оператора

Страница: 15 / 48

G020794
Figure 8
1. Pull frame 3. Ball stud
2. Pull arm
4. Mount the baskets on the pull frames, loosen the
jam nuts on the pull arms, and adjust the ball sockets
until there is 6 to 13 mm (1/4 to 1/2 inch) clearance
between the lip of the basket and the reel blades or the
front shield.
Note:
This prevents the basket from tipping the
cutting unit forward, causing the lift roller to come off
of the lift arm while in the mowing operation.
Be sure the basket lip is equidistant from the reel blades
all across each reel. If the basket is too close to the reel,
it is possible for the reel to contact the basket when the
cutting unit is raised off of the ground.
5. Align the sockets in the ball joints so the open side of
the socket is centered towards the ball stud. Tighten the
jam nuts to secure the sockets in position (Figure 9).
G020795
Figure 9
1. Pull arm 3. Ball joint
2. Jam nut
6. Ensure that there is approximately 13 mm (1/2 inch)
of threads exposed on each reel drive motor mounting
bolt (Figure 10).
Figure 10
1. Mounting bolts 2. Drive motor
7. Coat the spline shaft of the motor with clean grease
and install the motor by rotating the motor clockwise
so that the motor flanges clear the studs. Rotate the
motor counterclockwise until the flanges are encircling
the studs.
8. Tighten the mounting bolts (Figure 10).
5
Adding Rear Ballast and
Weight Kit
Parts needed for this procedure:
1 Rear weight kit, 100-6441 (purchase separately)
18 kg
(40 lb)
Calcium chloride (purchase separately)
1
Rear weight kit, 99-1645 (purchase separately if you
have a 3-wheel drive kit installed)
Procedure
This unit complies with the ANSI B71.4-2004 and EN 836
Standards when you equip it with rear weight kit 100-6441
and 18 kg (40 lb) of calcium chloride ballast is added to the
rear wheel. If you install a 3-Wheel Drive kit, use rear weight
kit 99-1645 instead of 100-6441.
Important:
If a puncture occurs in a tire with calcium
chloride, remove the unit from the turf area as quickly
as possible. To prevent possible damage to the turf,
immediately soak the affected area with water.
15