Toro GrandStand 74567TE, Руководство оператора

Страница: 43 / 64

Belt Maintenance
Replacing the Mower Deck
Belt
Service Interval: Every 100 hours—Check the mower
deck belt.
Squealing when the belt is rotating, blades slipping when
cutting grass, frayed belt edges, burn marks and cracks
are signs of a worn deck belt. Replace the deck belt if
any of these conditions are evident.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the bolts securing the belt covers and
remove the belt covers.
4. Loosen the front idler pulley by loosening the nut.
5. Remove the worn mower belt (Figure 62).
6. Install the new mower belt around the deck pulleys
and clutch pulley (Figure 62 ).
7. Using a ratchet in the idler arm, tighten the idler
pulley until the spring is stretched 5-3/4 inches (14.6
cm) from hook to hook (Figure 62 ).
8. Tighten the front idler pulley by tightening the nut.
9. Install the belt covers onto the cutting unit and
secure them with the previously removed bolts.
Figure 62
1. 5-3/4 inches (14.6 cm)
from hook to hook 4. Ratchet
2. Spring 5. Square hole for ratchet
3. Spring loaded idler 6. Nut
Replacing the Pump Drive Belt
Service Interval: Every 100 hours—Check the pump
drive belt.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the mower deck belt.
4. Tilt the machine on it’s back. Refer to
Pre-Maintenance at the beginning of the
Maintenance Section.
5. Disconnect the clutch wire connector from the wire
harness.
6. Disconnect the clutch retainer from the engine deck
(Figure 63).
43