Toro GrandStand 74567TE, Руководство оператора

Страница: 21 / 64

Figure 21
Driving Backward
1. Move the right side motion control lever to the
center, un-locked position.
2. Slowly pull the motion control levers rearward
(Figure 22).
Figure 22
Stopping the Machine
To stop the machine, move the motion control levers to
neutral, move the right side motion control lever into
the neutral lock position, disengage the power take off
(PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake in Operation. Remember
to remove the key from the ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the tractor while it
is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Pushing the Machine by Hand
The by-pass valves allow the machine to be pushed by
hand without the engine running.
Important:
Always push the machine by hand.
Never tow the machine because hydraulic damage
may occur.
To Push the Machine
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set the
parking brake.
2. Open the by-pass valve on both pumps by turning
them counter clockwise 1 to 2 turns. This allows
hydraulic fluid to by-pass the pumps and the wheels
to turn (Figure 23).
Note:
Rotate the by-pass valves a maximum of 2
turns so the valve does not come out of the body
causing fluid to run out.
Figure 23
1. Pump by-pass valve
21