Note:
Measure from the hood plate to the edge
of the tube as shown in
. This distance
needs to be 19 mm (3/4 inch).
g003388
Figure 22
1.
Hood plate
4.
3/4 inch (19 mm)
2.
Upper tube
5.
Edge of tube
3.
Hood in the down position
6.
Once the 19 mm (3/4 inch) measurement has
been achieved, mark the upper tube on the
outside where the rubber seal protrudes out
(
).
Note:
This is marked to ensure the correct
position for the upper tube when drilling the
holes and connecting the upper and lower tubes.
Note:
The rubber seal must protrude out from
the bagger hood.
g003393
Figure 23
1.
Upper tube
3.
Bagger hood
2.
Rubber seal protruding out
4.
Mark here against the
rubber seal.
19
