Operation
21
POTENTIAL HAZARD
•
Hydraulic fluid escaping under pressure
can penetrate skin and cause injury.
WHAT CAN HAPPEN
•
Fluid accidentally injected into the skin
must be surgically removed within a few
hours by a doctor familiar with this form of
injury or gangrene may result.
HOW TO AVOID THE HAZARD
•
Keep body and hands away from pin hole
leaks or nozzles that eject high pressure
hydraulic fluid.
•
Use cardboard or paper to find hydraulic
leaks, never use your hands.
POTENTIAL HAZARD
•
Hydraulic couplers, hydraulic lines/valves,
and hydraulic fluid may be hot.
WHAT CAN HAPPEN
•
Contact with hot hydraulic components or
fluid may cause burns.
HOW TO AVOID THE HAZARD
•
Wear gloves when operating the hydraulic
couplers.
•
Allow the traction unit to cool before
touching hydraulic components.
•
Do not touch hydraulic fluid spills.
7.
Push the attachment female connector onto the
male connector on the traction unit.
8.
Confirm that the connection is secure by pulling
on the hoses.
9.
Move the auxiliary hydraulics lever to neutral.
Removing an Attachment
1.
Lower the attachment to the ground
2.
Stop the engine.
3.
Disengage the quick attach pins by turning them
to the outside.
4.
If the attachment uses hydraulics, move the
auxiliary hydraulics lever forward, back and
forth, and back to neutral to relieve pressure at
the hydraulic couplers.
5.
If the attachment uses hydraulics, slide the collar
back on the hydraulic couplers and disconnect
them.
6.
Install the protective covers onto the hydraulic
couplers on the traction unit.
7.
Start the engine, tilt the mount plate forward,
and back the traction unit away from the
attachment.
Securing the Traction Unit for
Transport
IMPORTANT: Do not operate or drive the
traction unit on roadways.
IMPORTANT: When transporting the
traction unit on a trailer, always use the
following procedure:
1.
Lower the loader arms.
2.
Stop the engine.
3.
Set the parking brake.
4.
Secure the traction unit to the trailer with chains
or straps using the tie-down loops (Fig. 6) to
secure the rear of the traction unit and the loader
arms/mount plate to secure the front of the
traction unit.
Содержание Dingo TX 22306
Страница 7: ...Safety 5 Slope Chart...
