4.
Install the 2 relays to the bucket relay connectors
and continue to
.
Assembling the Relay Connectors
to the Machine
For Model 22327 with serial numbers after
316000467 and Model 22328 with serial
numbers after 316999999
1.
From the rear of the machine, remove both
existing relays from the ignition relay connectors
(
).
g242426
Figure 17
1.
Bucket relay connectors
3.
Ignition relay connectors
2.
Mating tangs
4.
Ignition relays
2.
Loosen the ignition relay connector mounting
bolts and nuts.
3.
Slide the mating tangs of the bucket relay
connectors onto the tangs of the left ignition
relay connector (
4.
Tighten the ignition relay connector mounting
hardware and install the relays removed in step
5.
Install the 2 relays to the bucket relay connectors
and continue to
.
Connecting the Power Lead
Branch
1.
With a cable tie, secure the harness to the hose
fitting in the T1 port on the left side of the loader
arm valve assembly.
Important:
Route the wire harness away
from any hot or moving parts, secure with
cable ties as needed.
2.
Open the hood, prop it up, and remove the heat
shield (
).
g038212
Figure 18
1.
Screw (3)
2.
Heat shield
3.
Feed the power lead branch forward and around
the front of the auxiliary valve.
4.
Remove the cap from the plug-and-socket
connector on the auxiliary low flow harness and
connect the power lead branch to the open
connector (
).
g038242
Figure 19
1.
Power lead connector
2.
Auxiliary low flow
connector
5.
Install the cap into the short, taped-back
connector on the power lead branch.
Note:
Secure the wire harness so that it does
not contact the heat shield.
12
