Toro Air Cool Z Master 96in 74090, Руководство пользователя программного обеспечения

Страница: 15 / 16

Troubleshooting
System Error Message Status LED System Actions Issue Description Recommended Corrective Action
Service the Engine Oil Blink Red
The engine oil service
is due.
Replace the engine oil and filter.
Follow the reset procedure; refer to
Engine Oil (page 11) .
Service the
Transmission Oil
Blink Red
The transmission oil
service is due.
Replace the transmission oil and
filter(s). Follow the reset procedure;
refer to
Hydraulic Transmission Oil
(page 10)
Low Oil Pressure Blink Red
Safe Transport
Mode—engine limited
to Efficient mode and the
PTO is disengaged.
The engine-oil
pressure is below
limit. Cycle the key switch to clear the
fault. Check the oil level. Contact an
Authorized Service Dealer.
Green
Single alarm chirp and
engine temperature
display flashes.
The engine
temperature is high.
Check the oil level. Clean debris from
the engine. Inspect the engine fan.
Contact an Authorized Service Dealer.
Engine Over
Temperature
Blink Red
Safe Transport
Mode—engine limited
to Efficient mode and the
PTO is disengaged.
The engine
temperature is above
limit. Check the oil level. Clean debris from
the engine. Inspect the engine fan.
Contact an Authorized Service Dealer.
Fuel Low Blink Red The fuel level is low.
Check the fuel level and add fuel as
necessary.
System Overvoltage
>16VDC
Blink Red
Disallow clutch
engagement/ Disengage
the clutch. The system voltage is
excessive (above 16
V). Check the battery and engine
charging system. Contact an
Authorized Service Dealer.
System Voltage Low Blink Red
System voltage below
12.3 V.
Check the battery and engine
charging system. Contact an
Authorized Service Dealer.
System Under
voltage<9VDC
Blink Red
Disallow clutch
engagement/ Disengage
clutch. The system voltage is
below the lower limit
of 9 V. Check the battery and engine
charging system. Contact an
Authorized Service Dealer.
Clutch Overcurrent Blink Red
Safe Transport
Mode—engine limited
to Efficient mode and the
PTO is disengaged.
The clutch current is
above the limit.
Cycle the key switch to clear the
fault. Check the PTO clutch condition
and the related wiring. Contact an
Authorized Service Dealer.
Clutch Reset Required
Alternating
green/orange
The PTO switch is
engaged and the
module has latched
the clutch output Off.
Cycle the PTO switch to the O
FF
position and back to the O
N
position
to engage the clutch.
Clutch Output Fault Blink Red
The clutch output has
a short or is open.
If the clutch is stuck in the O
N
position,
discontinue use and contact an
Authorized Service Dealer. Check
the clutch connection and associated
wiring for an open circuit.
Engine MIL Errors Blink Red
The ECU has detected
a fault.
See the engine owner’s manual for the
error description and troubleshooting
information.
Engine
Communication Error
Blink Red
The communication
between the module
and the engine ECU
has been lost.
Check the electrical connections at
the module, interconnect between
the engine wire harness, and chassis
harness. Check the connections
at the engine ECU. Contact an
Authorized Service Dealer.
15