4
1
2
Figure 8
1.
Relay
2.
Relay connector
17. Cut and strip the brown wire with the white stripe from
the bottom of the relay connector (Fig. 9).
Figure 9
18. Splice the brown wire with the white stripe with the
end of the long harness supplied in this kit, using a
heat shrink tube to seal them together (Fig. 10).
1
2
Figure 10
1.
Long wire harness
2.
Heat-shrink connection
19. Plug the relay connector into the relay.
20. Connect the end of the long wire harness to the other
lead on the new gray module (Fig. 11).
1
2
Figure 11
1.
New gray module
2.
Long wire harness
21. Set the transaxle speed; refer to the Service Manual for
instructions.
22. Install the torque arm onto the studs on the transaxle
assembly and to the back of the engine (Fig. 5).
