Toro 74920 TITAN ZX4820, Руководство оператора

Страница: 23 / 60

G008952
Figure 24
Driving Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control levers
rearward (Figure 25).
G008953
Figure 25
Stopping the Machine
WARNING
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and move the
motion control levers outward to the park position
when leaving the machine unattended, even if just
for a few minutes.
To stop the machine, move the traction control levers to
neutral and move to locked position, disengage the blade
control switch (PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer to
Setting the Parking Brake. Remember to remove the key from
the ignition switch.
Adjusting the Height of Cut
The machine is equipped with a foot pedal deck lift system.
The operator can use the foot pedal to lift the deck briefly to
avoid obstacles or lock the deck in the highest height-of-cut
or transport position. The operator can use the height of
cut lever with the foot pedal to lock the deck in a specific
cutting height.
Using the Foot Pedal Deck Lift System
Press the pedal down to raise the deck; continue to press
the pedal until the deck is locked in the transport position
Figure 26. Push on the deck lift pedal with your foot and raise
the height-of-cut lever slightly to disengage the transport lock.
23