Toro 74710 TimeCutter SS 3225, Руководство оператора

Страница: 12 / 48

Product Overview
Figure 4
1. Footrest 8. Engine
2. Deflector 9. Fuel-tank cap
3. Height-of-cut lever 10. Rear drive wheel
4. Motion-control lever
11. Washout fitting
5. Smart-speed lever 12. Mower deck
6. Control panel 13. Front caster wheels
7. Operator seat
Controls
Become familiar with all of the controls in Figure 4 and
Figure 5 before you start the engine and operate the machine.
Figure 5
Control Panel
1. Throttle/Choke 3. Blade-control switch
(power take-off)
2. Ignition switch
Ignition Switch
The ignition switch has 3 positions: Off, Run, and Start. The
key will turn to Start and move back to Run upon release.
Turning the key to the Off position will stop the engine;
however, always remove the key when leaving the machine
to prevent someone from accidentally starting the engine
(
Figure 5 ).
Throttle/Choke Control
The throttle and choke are combined into one control lever.
The throttle controls the engine speed and it has a continuous
variable setting from Slow to Fast. Engage the choke by
moving the lever past the Fast setting until it stops (
Figure 5 ).
It may be necessary to hold the lever against the stop, in the
choke position, while trying to start the engine.
Note:
A warm or hot engine may not require choking.
Blade-Control Switch (Power Take-off)
The blade-control switch, represented by a power take-off
(PTO) symbol, engages and disengages power to the mower
blades (
Figure 5 ).
Motion-Control Levers and Park
Position
The motion-control levers are speed-sensitive controls of
independent-wheel motors. Moving a lever forward or
backward turns the wheel on the same side forward or in
reverse; wheel speed is proportional to the amount the lever
is moved. Move the control levers outward from the center
12