Toro 74593, Руководство оператора

Страница: 16 / 40

3. Turn the KeyChoice key.
A red light on the front console (Figure 14) turns
on, indicating that the interlock is disabled.
Figure 14
1. Operating-in-reverse light
4. Operate the machine in reverse and complete your
task.
5. Disengage the blades (PTO) to activate the
interlock.
6. Remove the KeyChoice key and put it in a safe place
out of the reach of children.
Testing the Safety Interlock
System
If the safety interlock switches are disconnected
or damaged, the machine could operate
unexpectedly, causing personal injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Test the safety interlock system before you use the
machine each time. If the safety interlock system does
not operate as described below, have an Authorized
Service Dealer repair the safety interlock system
immediately. While sitting in the seat, perform the
following checks:
1. Set the parking brake, shift the blade control (PTO)
knob to the Engage position, and turn the ignition
key to Start: The engine should not crank.
2. Shift the blade control (PTO) knob to the Disengage
position, release the parking brake, and turn the
ignition key to Start: The engine should not crank.
3. Set the parking brake, shift the blade control (PTO)
knob to Disengage, and start the engine. While the
engine is running, release the parking brake and rise
slightly from the seat: The engine should stop.
4. Shift the blade control (PTO) knob into the
Disengage position, put the traction control pedal
in Neutral, and start the engine. While the engine
is running, shift the blade control (PTO) knob into
the Engage position and put the traction control
pedal in Reverse: The engine should stop.
5. Shift the blade control (PTO) knob into the
Disengage position and put the traction control
pedal in Neutral. Start the engine, shift the blade
control (PTO) knob into the Engage position,
and turn the KeyChoice key and release it: The
operating-in-reverse warning light should illuminate.
6. Shift the blade control (PTO) knob to the Disengage
position: The operating-in-reverse warning light
should turn off.
Pushing the Machine Manually
Important:
Always push the machine manually.
Never tow the machine because it may damage
the transaxle.
To Push the Machine
1. Park the machine on a level surface.
2. Disengage the blades (PTO).
3. Set the parking brake.
4. Stop the engine and wait for all moving parts to
stop.
5. Remove the ignition key.
6. Remove the grass collector; refer to Removing the
Grass Collector.
7. Pull the drive control (located at the rear of the
machine), out to the Push position.
8. Release the parking brake.
Note:
This disengages the drive system and allows the
wheels to turn freely (Figure 15).
16