g036746
Figure 56
1.
Roll bar in the upright
position
4.
Rotate the roll-bar knob 90
degrees.
2.
Roll-bar knob in the
latched position
5.
Roll-bar knob in the
unlatched position
3.
Pull the roll-bar knob out
and rotate it 90 degrees.
6.
Roll bar in the folded
position
g034593
Figure 57
1.
Engaged
2.
Partially engaged—do not
operate with the roll bar in
this position.
Adjusting the Tracking
1.
Disengage the blade-control switch (PTO).
2.
Drive to an open, flat area and move the motion-control
levers to the N
EUTRAL
-
LOCK
position.
3.
Move the throttle midway between the F
AST
and S
LOW
positions.
4.
Move both motion-control levers forward until they
both hit the stops in the T-slot.
5.
Check which way the machine tracks.
6.
If the machine tracks to the right, insert a 3/16 inch
hex wrench through the access hole in the right front
cover panel and rotate the tracking screw clockwise
or counterclockwise to adjust the travel of the lever
(
).
7.
If the machine tracks to the left, insert a 3/16 inch
hex wrench through the access hole in the right front
cover panel and rotate the tracking screw clockwise
or counterclockwise to adjust the travel of the lever
(
).
8.
Drive the machine and check the full forward tracking.
9.
Repeat the adjustment until the desired tracking is
obtained.
g035859
Figure 58
Right control lever shown
1.
Access hole on front cover
panel
2.
Tracking screw
44
