Toro 68021HD, Руководство оператора

Страница: 24 / 44

Using the Drum
DANGER
Contact with the mixing paddles could cause
damage or injury.
Never put your hands inside the drum while the
engine is running.
Dumping the Drum
Note:
When dumping a batch of material, leave the engine
running and the clutch in the O
N
position so the rotating
paddles help discharge the material.
1. Align a wheelbarrow or similar container of adequate
capacity in the path of the drum opening.
2. Grasp the dump handle with your left hand ( Figure 31 ).
Figure 31
1. Dump handle—Mix
position 3. Drum latch—Locked
position
2. Drum latch—Release
position 4. Dump handle—Dump
position
Note:
When dumping a batch of material, align a
wheelbarrow or a similar container of adequate capacity
beneath the chute.
3. Lift the handle of the drum latch ( Figure 31 ).
4. With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of the
drum (
Figure 31 ).
Note:
Allow the machine to completely discharge the
contents of the drum.
5. Rotate the dump handle clockwise until the drum
latch locks the drum in the upright position ( Figure 31 ).
6. After discharging a batch of material, clean the drum;
refer to
Cleaning the Drum (page 24) .
Note:
This step cleans the paddles and drum between
batches and prevents dried material from forming and
contaminating the next batch of material.
Cleaning the Drum
Important:
Do not strike on the drum with a shovel,
hammer, or any other device to loosen any accumulated
dried materials.
1. Stop the rotation of the paddles by moving the clutch
lever to the O
FF
position.
2. Rotate the engine On/Off switch to the O
FF
position.
3. Ensure that the drum is in the mix position (upright).
4. Spray the machine with water to remove any
accumulated material.
5. Start the engine.
6. Start the rotation of the paddles by moving the clutch
lever to the O
N
position.
7. Dump the drum.
Adjusting the Paddle Blades
Note:
Adjusting the paddle blades is optional.
1. Shut off the engine and wait for all moving parts to
stop.
2. Disconnect the wire from the spark plug; refer to
Disconnecting the Spark-Plug Wire (page 27) .
3. Remove the nuts and bolts that secure the grate to the
drum, and remove the grate (
Figure 32 ).
G022161
Figure 32
24