Toro 66210T, Руководство оператора

Страница: 14 / 20

Maintenance
After each use of the trimmer, complete the following:
1. Remove the battery from the trimmer.
2. Wipe the trimmer clean with a damp cloth. Do
not hose the trimmer down or submerge it in
water.
CAUTION
The line cutoff blade on the deflector is
sharp and can cut you.
Do not use your hands to clean the
deflector shield and blade.
3. Wipe or scrape clean the cutting head area any
time there is an accumulation of debris.
4. Check and tighten all fasteners. If any part is
damaged or lost, repair or replace it.
5. Brush debris away from air intake vents and
exhaust on motor housing to prevent the motor
from overheating.
Replacing the Line
Use only 2.4 mm (0.095 inch) diameter monofilament
line (manufacturer Part No. 88612).
1. Remove the battery pack.
2. Remove any existing line on the spool by
repetitively pressing the bump head while pulling
the line out equally from both sides of the bump
head.
3. Using 2.4 mm (0.095 inch) line, cut one piece of
line approximately 7.3 m (24 ft).
Important:
Do not use any other gauge
or type of line, as this could damage the
trimmer.
4. Press and turn the bottom of the trimmer head
clockwise until the bottom green marks align
with the green marks beneath the eyelets
(
Figure 15 ).
5. Insert 1 end of the line straight into the eyelet
and push the line through until it comes out
through the eyelet on the other side.
g367291
Figure 15
Some parts not shown for clarity
1. Eyelet 3. Eyelet alignment mark
2. Line 4. Bottom alignment mark
Important:
Do not disassemble the trimmer
head.
6. Pull the line through the trimmer head until there
is an equal length of line on each side.
7. Hold the string trimmer in place with one hand.
With your other hand, turn the bottom of the
trimmer head in the direction shown by the
arrows (clockwise) on the bottom of the bump
head to wind the line; leave about 152 mm (6
inches) extending beyond the eyelet on each
side.
14