Toro 60213, Руководство оператора

Страница: 26 / 52

4. With both hands on the dump handle, rotate it
counterclockwise to discharge the contents of
the drum (
Figure 33 ).
Note:
Allow the machine to completely
discharge the contents of the drum.
5. Rotate the dump handle clockwise until the
drum latch locks the drum in the upright position
(
Figure 33 ).
6. After dumping a batch of material, clean
the drum to prevent dried material from
contaminating the next batch of material; refer to
Cleaning the Drum (page 26) .
Cleaning the Drum
Important:
Do not strike on the drum with a
shovel, hammer, or any other device to loosen any
accumulated dried materials.
1. Move the clutch lever to the O
FF
position to stop
the paddles.
2. Shut off the engine/motor.
3. Ensure that the drum is in the mix position
(upright).
4. Spray the machine with water to remove any
accumulated material.
5. Start the engine/motor.
6. Move the clutch lever to the O
N
position to start
the paddles.
7. Dump the drum.
26