Toro 51958, Руководство оператора

Страница: 15 / 82

15
WARNING:
Always shut off engine before fueling. Never
remove fuel cap or add fuel to a machine with
a running or hot engine. Make sure the unit is
sitting on a flat, level surface and only add fuel
outdoors. If the engine is hot, let the unit cool
for at least five minutes before adding fuel.
After fueling, immediately replace fuel cap and
tighten securely. Move at least 30 ft. from refu -
eling site before starting engine. Do not smoke
and stay away from open flames and sparks!
Failure to follow these instructions could result
in a fire and cause serious personal injury.
Starting the Product
See Figures 6 - 7.
Starting the product differs depending on whether the engine
is cold or warm. Refer to the label on the air filter cover.
To Start a Cold Engine:
Follow these steps to start a cold engine.
1.
Lay the product on a flat, bare surface.
2. Push the primer bulb approximately eight times.
3.
Set the choke lever to
FULL CHOKE
.
4. Depress trigger lock-out and squeeze throttle trigger
fully (thru step 7) and pull starter grip and rope sharply
until engine attempts to start (no more than 4x).
5.
Set the choke lever to
HALF CHOKE
.
6.
Pull starter grip and rope until engine runs,
no more
than 6 pulls.
7.
Set the choke lever to
RUN
.
Note
:
In cooler environments, additional pulls of the
starter grip and rope may be required with the choke
lever in the
FULL CHOKE
position.
Figure 7
To Start a Warm Engine:
Follow these steps to start a warm engine.
1.
Lay the product on a flat, bare surface.
2.
Push the primer bulb up to eight times.
3.
Set the choke lever to
RUN
.
4.
Depress trigger lock-out and squeeze throttle trigger
fully, pull the sstarter grip and rope.
Note:
If the product does not start, repeat the previous
steps.
Stopping the Product
See Figure 8.
Follow these steps to stop the product.
1.
Release the trigger.
2.
Press and hold on/stop switch to (STOP) position until
the engine stops. The switch will automatically return to
the (ON) position when released.
Operation
Set Choke to FULL
Set Choke to RUN
Throttle
Trigger
On/Stop
Switch
Figure 8
Figure 6
Lock-out
Switch
Starter
Grip and
Rope
Throttle
Trigger
Primer
Bulb
On/Stop
Switch