Toro 51487A, Руководство оператора

Страница: 11 / 20

Replacing the Spool
Use only 1.6 mm (.065 inch) diameter monofilament string. Use
original manufacturer’s replacement string for best performance
(Toro part number 88532(A) or 88524(A)).
Important:
Use of a larger diameter string will cause
the motor to overheat and fail.
1. Remove the battery.
2. Push in the tabs on the side of the spool retainer ( Figure 18 ).
1
2
3
4
G015663
Figure 18
1. Spool retainer 3. Slots
2. Spool
4. Tabs
3. Pull the spool retainer up to remove it, and remove the spool.
4. To install the new spool, make sure the string is captured in
one of the retaining slots on the new spool. Make sure the
end of the string extends approximately 152 mm (6 inches).
5. Install the new spool so that the string aligns with the eyelet
in the string head. Thread the string into the eyelet.
6. Pull the string extending from the string head so that the
string releases from the slot in the spool.
7. Install the spool retainer by depressing tabs into slots and
pushing down until the spool retainer clicks into place.
Replacing the String
1. Remove the battery.
2. Remove the spool. See Replacing the Spool ( Figure 18 ).
1
2
G015662
Figure 19
1. Slot in upper spool flange 2. Hole
Note:
Remove any old string remaining on the spool.
3. The spool will accept up to 4.5 m (15 feet) of string. Use
only 1.6 mm (.065 inch) diameter monofilament string.
Note:
Do not use any other gauge or type of string, as
this could damage the trimmer.
4. Insert the string into the anchor hole in the upper part of
the spool (
Figure 19 ). Wind the string onto the spool in the
direction shown by the arrows on the spool.
5. Place the string in the slot on the upper spool flange, leaving
about 152 mm (6 inches) extended beyond the slot.
Note:
Do not overfill. After winding the string, there
should be at least 6 mm (1/4 inch) between the wound
string and the outside edge of the spool.
6. Replace the spool and the spool retainer. Refer to Replacing
the Spool (page 11) .
Preparing the Battery Pack for
Recycling
WARNING
Before recycling, cover the battery pack's terminals
with heavy-duty adhesive tape. Do not attempt to
destroy or disassemble the battery pack or remove
any of its components. Lithium-ion batteries must be
recycled or disposed of properly at the nearest battery
recycling facility.
11