5.
Install the new spool so that the string ends align with
the eyelets in the string head, and thread the string ends
through the eyelets.
6.
Pull the strings extending from the string head so that the
strings release from the slots in the spool.
7.
Install the spool retainer by pressing the tabs into the slots
and pushing down on the spool until the spool retainer clicks
into place.
Replacing the String
Important:
Use only 1.65 mm (0.065 inch) diameter
monofilament string. Do not use any other gauge or type of
string, as this could damage the trimmer.
1.
Remove the spool; refer to
Replacing the Spool (page 10)
.
2.
Remove any string remaining on the spool.
3.
Insert the string into the anchor hole in the upper part of
the spool (
).
g021146
Figure 12
1.
Slot in upper spool flange
3.
Slot in lower spool flange
2.
Hole
Note:
Wind the string onto the spool in the direction
shown by the arrows on the spool.
Note:
The spool can accept up to 4.6 m (15 ft) of string.
4.
Place the string ends in the slots on the upper spool flange,
leaving about 152 mm (6 inches) beyond the slot.
Note:
Do not overfill the spool. After winding the string,
there should be at least 6 mm (1/4 inch) between each of the
wound strings and the outside edge of the spool.
5.
Replace the spool and the spool retainer; refer to
.
Service
Toro has designed this product to give you years of trouble-free
use. Should it need service, bring the product to your Authorized
Service Dealer.
Storage
Disconnect the trimmer from the power source, and store the
trimmer and the extension cord indoors in a cool, dry location and
out of the reach of children and animals.
Important:
Do not rest the trimmer on the guard, or it may
warp and interfere with the cutting line.
Note:
Devices for retaining extension cords are commercially
available.
11
