5.
Verify that the telescoping tube has a minimum
of 150 mm (6 inches) overlap when the
attachment is raised to the maximum height.
g345507
Figure 18
Connecting the Hydraulic
Hoses
1.
Connect the hydraulic hoses from the attachment
to the traction unit. Ensure the hydraulic hoses
are engaged in the ports.
2.
Confirm that the traction unit levers operate the
attachment hydraulics.
Adjusting the Working
Depth
The working depth is set by adjusting the front roller.
Ensure the rear roller is set to the long slot for cutting
and scarifying (
Important:
Adjust the working depth only when
the traction unit is parked, the parking brake is
engaged, the PTO is disengaged, and the engine
is shut off.
1.
Loosen the jam nut on the top of each rear link.
2.
Adjust the rear links until they align with the long
slot in the gauge (
3.
Tighten the jam nut on the top of each rear link
(
).
g346323
Figure 19
1.
Rear link
4.
Rear link
2.
Jam nut
5.
Long slot in gauge
3.
Gauge
4.
Loosen the jam nut on each front link.
5.
Adjust the front links to your desired depth by
using the indicators on the sides.
6.
Tighten the jam nut on each front link.
7.
Check the working depth by running the machine
a few meters (yards). Refer to
Attachment (page 15)
.
8.
If needed, adjust the front links until you reach
your desired depth.
Note:
When the lift conveyor is folded out, the
machine weight shifts to this side. Due to the
extra weight, you can remove more material on
this side. To compensate for this extra weight,
adjust the front and back links on the right side
(lift conveyor side).
13
