8.
Install the brake spring onto the idler arm (
Figure 38
).
9.
Install the drive belt cover with the bolts that you
removed in step
1
.
Note:
Ensure that the drive belt is properly adjusted
and operating; refer to
Checking the Control Cable
(page 12)
and
Adjusting the Control Cable (page 13)
.
Adjusting the Quick Shoot™
Control
If there is more than 13 mm (1/2 inch) of slack in the Quick
Shoot cable (
Figure 39
) or the discharge chute does not rotate
left and right in equal angles, adjust the Quick Shoot control
cables.
Figure 39
1.
13 mm (1/2 inch) maximum slack
1.
Loosen the 2 Quick Shoot control-cable clamps (
Figure
40
).
Figure 40
1.
Cable clamps
2.
Position the Quick Shoot control between the 2 arrows
located on the right side of the upper handle (
Figure
41
).
Figure 41
1.
Arrows
3.
Rotate the discharge chute so that it faces straight
ahead and the arrow on the back of the discharge chute
aligns with the arrow on the shroud (
Figure 42
).
Figure 42
17
Содержание 38744
Страница 20: ...Notes ...
Страница 21: ...Notes ...
