Toro 38682, Руководство оператора

Страница: 18 / 40

3. Remove the lower bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Figure 14).
4. Pivot the handle to the desired operating position
and install the lower flange bolts (3/8 x 1 inch)and
flange nuts into the mounting holes. Tighten all
flange bolts.
Figure 14
1. Upper handle 6. Lower mounting holes
2. Rear frame 7. Low position
3. Flange bolt (3/8 x 1 inch) 8. Middle position
4. Lock nut (3/8 inch) 9. High position
5. Upper mounting hole
5. Adjust the control rod length by rotating the control
rod in the rod fitting (Figure 13).
6. Install a hairpin cotter between the drive levers and
neutral locks and into the clevis pins (Figure 13).
Note:
Make sure the clevis pins are inserted into
the neutral locks.
7. Check the parking brake adjustment. Refer to
Checking the Brakes in Brake Maintenance.
18