Figure 55
1.
Cable conduit
2.
Cable clamp
3. Grasp the cable conduit and move it toward the front
of the machine until the discharge chute latch fully
engages the gear teeth (Figure 55 and Figure 56).
Figure 56
1.
Discharge chute latch
2.
Gear teeth
Note:
The latch is spring loaded and will naturally
move into the teeth of the gear (Figure 56).
4. Remove any slack in the cable by pulling the cable
conduit rearward.
5. Tighten the bolt on the cable clamp.
6. Install and secure the gear cover.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction drive belt
becomes worn, oil-soaked, or otherwise damaged, go
to www.Toro.com for additional service information or
have an Authorized Service Dealer replace the belt.
Replacing the Headlight Bulb
Use a
GE 892 16W halogen light bulb.
Do not touch
the bulb with your hands or allow dirt or moisture to
come into contact with the bulb.
1. Remove the wire connector from the back of the
headlight (Figure 57).
Figure 57
2. Turn the base of the bulb counterclockwise until it
stops (Figure 58).
Figure 58
3. Remove the bulb straight out from the back of the
headlight (Figure 59).
Figure 59
4. Insert a new bulb into the back of the headlight
(Figure 60).
Figure 60
5. Turn the base of the bulb clockwise until it is snug
(Figure 61).
23
