Toro 38063, Руководство оператора

Страница: 20 / 28

20
5. Loosen the four flange nuts that secure both skids to the
auger side plates (Fig. 19) until the skids slide up and
down easily.
651
1
3
2
Figure 19
1. Skid (2)
2. Flange nuts (4)
3. Auger side plate (2)
6. Support the auger blades so that they are 1/8 inch
(3 millimeters) off the ground (Fig. 20).
652
1
3
2
2
Figure 20
1. Scraper
2. Mounting screws
3. Auger blades
7. Check the scraper adjustment. The scraper should be
1/8 inch (3 millimeters) above and parallel to a level
surface.
For Concrete and Asphalt Surfaces:
If the snowthrower does not clear the snow close enough to
the pavement, adjust the skids to lower the scraper; if the
pavement surfaces are cracked, rough, or uneven, adjust the
skids to raise the scraper.
For Gravel Surfaces:
Support the auger blades a few inches (centimeters) above
the ground, and adjust the skids to prevent the snowthrower
from picking up rocks.
8. To adjust the scraper, loosen the five mounting screws
(Fig. 20), level the scraper, and tighten the mounting
screws.
9. Move the skids down as far as possible.
10. Tighten the four flange nuts that secure both skids to the
auger side plates (Fig. 19).
11. Connect the wire to the spark plug.
Adjusting the Speed Selector
Adjust the speed selector linkage initially and when the
snowthrower is slow, first gear has no speed, or the speed
selector does not move into third gear.
1. Stop the engine and wait for all moving parts to stop.
2. Disconnect the wire from the spark plug and ensure that
the wire does not contact the spark plug (Fig. 15).
3. Tip the snowthrower forward and block it so that it
cannot fall.
4. Remove the four flange-head bolts that secure the
bottom cover to the frame and remove the cover
(Fig. 25).
5. Loosen the flange nuts that secure the selector plate to
the control panel (Fig. 21).
659
2
1
Figure 21
1. Speed selector plate 2. Flange nuts
6. Shift the speed selector to third gear and push down on
the speed selector plate to move the drive assembly to
the right.
Note: The drive assembly should be 1/8 inch
(3 millimeters) from the roll pin; if not, slide the
selector plate (Fig. 21) until the gap is 1/8 inch
(3 millimeters); refer to Figure 22.