Toro 37797, Руководство оператора

Страница: 19 / 28

3. Loosen or tighten the turnbuckle to adjust the
spring length to 7 cm (2-3/4 inches) as shown
in
Figure 35 .
g031000
Figure 35
1. Jam nut 3. Spring
2. Turnbuckle 4. 7 cm (2-3/4 inches)
4. Tighten the jam nut ( Figure 35 ), ensuring that
there is slight tension on the cable.
5. If the auger/impeller cable is properly adjusted
but a problem remains, contact an Authorized
Service Dealer.
Checking the
Auger-Gearbox-Oil Level
Service Interval: Yearly—Check the auger-gearbox
oil and add oil if necessary.
1. Move the machine to a level surface.
2. Clean the area around the pipe plug ( Figure 36 ).
g016782
Figure 36
1. Pipe plug
3. Remove the pipe plug from the gearbox.
4. Check the oil level in the gearbox. The oil should
be 9.5 mm (3/8 inch) below the filler opening.
5. If the oil level is low, add GL-5 or GL-6, SAE
80-90 EP gear oil lubricant to the gearbox until
the oil level is 9.5 mm (3/8 inch) below the filler
opening.
Note:
Do not use synthetic oil.
6. Install the pipe plug in the gearbox.
Changing the Engine Oil
Service Interval: After the first 5 hours—Change the
engine oil.
Yearly—Change the engine oil.
If possible, run the engine for a few minutes before
changing the oil because warm oil flows better and
carries more contaminants.
Engine oil capacity 0.70 L (24 fl oz)
Oil viscosity Refer to Figure 37 .
API service classification SJ or higher
Use Figure 37 below to select the best oil viscosity for
the outdoor temperature range expected:
g019049
Figure 37
1. Clean the area around the oil-drain cap ( Figure
38 ).
g001026
Figure 38
1. Oil-drain cap
19