g016645
Figure 41
1.
Spark-plug boot
2.
Clean around the base of the spark plug.
g016646
Figure 42
3.
Remove and discard the old spark plug.
Note:
You will need a ratchet wrench extension
to remove the spark plug.
4.
Set the gap between the electrodes on a new
spark plug at 0.76 mm (0.030 inch) as shown
in
g001029
Figure 43
1.
0.76 mm (0.030 inch)
5.
Install the new spark plug, tighten it firmly, and
attach the ignition wire to the spark plug.
Note:
Ensure that the ignition wire snaps
completely into place on the spark plug.
Adjusting the
Discharge-Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge-chute latch.
1.
Loosen the clamp fastener on the chute-support
plate until the cable is free.
g019021
Figure 44
1.
Cable conduit
3.
Clamp fastener
2.
Cable clamp
2.
Remove any slack in the cable by pulling the
cable conduit rearward.
3.
Tighten the clamp fastener while holding the
cable in place.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
Replacing the Headlight
Bulb
Use a Toro light bulb or equivalent (GE 899 37W
halogen bulb). Do not touch the bulb with your hands
or allow dirt or moisture to come into contact with the
bulb.
1.
Remove the wire connector from the back of the
headlight (
21
