Toro 34215, Руководство оператора

Страница: 31 / 80

3. Lock the spreader-pattern control by turning the
handle clockwise 90°; refer to 5 of
Figure 30 .
Using the Deflector Gate
Use the deflector-gate control to temporarily stop or
deflect granular material away from sidewalks, parking
lots, patios, or anywhere the granular chemicals are
not desired.
Note:
The deflector gate changes the discharged of
materials from the left side of the spreader only.
•
Push the knob for the deflector-gate control down
to lower the deflector and temporarily block the
granular material.
•
Pull the knob to raise the deflector to cast materials
normally at the left side of the machine.
g027373
Figure 31
1. Fence
3. Deflector gate lowered
2. Flowers
Spreading Material
1. Start the engine and place the throttle midway
between the S
LOW
and the F
AST
positions.
2. Set the impeller-speed control to appropriate
broadcast rate and then press the impeller
On/Off switch to the O
N
position ( Figure 32 ).
g027483
Figure 32
1. Indicator light 4. Impeller-speed control
2. Impeller On/Off switch 5. Spreader-motor and
sprayer-motor controller
3. Icon—press and hold the
impeller On/Off button 5
seconds
•
To lock the impeller speed control, press and
hold the impeller On/Off switch for 5 seconds
(
Figure 32 ).
Note:
The indicator light above the impeller
On/Off switch will flash at a constant rate.
If the impeller-speed control is locked
(indicated by the flashing indicator light), the
impeller motor will start and run at the last
locked speed.
•
To unlock the impeller-speed control, start
the impeller motor and then press and
hold press and hold the On/Off switch for
5 seconds (the indicator light will illuminate
steadily).
31