Toro 322006065, Руководство оператора

Страница: 21 / 24

Troubleshooting
Problem Possible Cause Corrective Action
1. The spark-plug wire is loose or
disconnected.
1. Install the wire on the spark plug.
2. The spark plug is wet, pitted, fouled, or
the gap is incorrect.
2. Install a new, correctly gapped spark
plug.
3. The fuel tank is empty. 3. Fill the fuel tank.
4. The air filter is dirty. 4. Replace the air filter.
5. There is dirt in fuel filter. 5. Replace the fuel filter.
6. The carburetor or fuel line is dirty. 6. Clean the carburetor or fuel line.
7. The carburetor is out of adjustment. 7. Contact an Authorized Service Dealer
8. The engine switch is in the O
FF
posiiton.
8. Move the switch to the O
N
position.
9. Dirt, water, or stale fuel is in fuel
system.
9. Contact an Authorized Service Dealer.
The engine does not start.
10. The engine switch or wire is defective. 10. Inspect and replace damaged parts.
1. The spark plug is faulty. 1. Replace the spark plug.
2. The air filter is dirty. 2. Replace the air filter.
3. The carburetor is out of adjustment. 3. Contact an Authorized Service Dealer
4. Dirt, water, or stale fuel is in fuel
system.
4. Contact an Authorized Service Dealer.
The engine runs poorly.
5. The engine cooling system is clogged. 5. Clean the debris screen and engine
cooling fans.
1. The engine cooling system is clogged. 1. Clean the debris screen and engine
cooling fans.
2. The carburetor is out of adjustment. 2. Contact an Authorized Service Dealer
The engine overheats.
3. The engine-oil level is low. 3. Add engine oil.
1. The engine on/off switch is damaged. 1. Inspect and replace damaged parts The engine does not shut off.
2. The wire disconnected from the engine
on/off switch.
2. Inspect, repair, or replace damaged
parts.
Mowing performance is poor. 1. The mower line length is too short. 1. Use the correct line length. When the
line is less than half this length, replace
it.
1. The capscrews for the mower head
are loose.
1. Tighten the capscrews.
2. The mower line lengths are
substantially different.
2. Adjust the mower line lengths to
approximately equal lengths.
3. A nut or bolt is loose. 3. Check all bolts and nuts, including
engine bolts.
The mower vibrates.
4. The mower head is broken. 4. Replace broken parts.
1. The mower line is not properly
attached.
1. Attach the mower line correctly.
2. The line retainer is broken. 2. Replace the mower head assembly.
The mower head does not retain line.
3. The mower line is not the correct size. 3. Use a mower line with a 4 mm (0.155
inch) diameter.
21